A furnace that leaks water almost always has a drainage problem. High-efficiency gas furnaces (90% AFUE and up) make water as part of normal heating, and that water has to drain through a trap, a drain line and sometimes a condensate pump. When one of those clogs, cracks or freezes, water ends up on the floor. A leak can also come from a whole-home humidifier or the AC coil that sits on top of the furnace. Turn the system off at the thermostat, mop up the water, and call The Air Company of GA at 404-583-7788. We're open 24 hours and serve homes and businesses across Atlanta, Sandy Springs, Marietta, Roswell, Alpharetta, Decatur and nearby cities.
Why Would a Furnace Leak Water in Winter?
A high-efficiency furnace pulls extra heat out of its exhaust gases. As those gases cool, moisture in them turns into water, called condensate. A busy furnace on a cold Atlanta night can make several gallons a day. That's normal. The water only becomes a problem when it can't get to the drain.
Older standard-efficiency furnaces (around 80% AFUE) aren't supposed to make water at all. If one of those is dripping, the exhaust may be cooling and condensing inside the vent pipe, and that needs a technician to look at the venting right away.
7 Common Causes of a Furnace Leaking Water
- Clogged condensate trap. The trap holds a little water to keep exhaust out of the drain. Over time it fills with sludge and backs up into the furnace.
- Blocked or disconnected drain line. The small PVC or vinyl line that carries water to a floor drain or outside can clog with algae or pull loose at a fitting.
- Failed condensate pump. Furnaces in basements and some closets use a small pump to lift water out. If the pump's motor or float switch fails, the reservoir overflows. Read more in our post on condensate pumps.
- Frozen drain line. Many homes in Atlanta, Brookhaven and Dunwoody have furnaces in attics or garages. During a hard freeze, a drain line that runs through cold space can freeze and back water up into the unit.
- Cracked or loose PVC vent pipe. High-efficiency furnaces vent through PVC pipe. If a joint separates or the pipe isn't sloped back toward the furnace, condensate drips out at the joint.
- Leaking whole-home humidifier. A humidifier mounted on the furnace uses a water line and a drain. A stuck valve, worn pad or clogged drain can send water down the side of the cabinet. See our indoor air quality page for humidifier service.
- AC coil drain pan above the furnace. The indoor AC or heat pump coil sits right on top of most furnaces. A rusted pan or clogged line can still drip after a fall warm spell. Our post on why an HVAC system leaks water covers the cooling side.
What to Do When Your Furnace Is Leaking
- Set the thermostat to Off so the furnace stops making more water.
- Mop up the water and move boxes or stored items away from the unit.
- Look for a condensate pump next to the furnace. If its reservoir is full and the pump isn't running, check that it's plugged in.
- Check whether the drain line has pulled loose from the furnace or the pump.
- If a humidifier is attached, turn off its water supply valve.
- Don't open the furnace cabinet or cut into the vent pipe. Those parts carry gas, electricity and exhaust.
If the leak keeps coming back, the furnace shuts off on its own, or you smell gas or exhaust, stop and call a professional. Smell gas? Leave the house and call your gas company first. Our post on preventing carbon monoxide leaks explains why venting problems matter.
Can a Water Leak Damage My Furnace?
Yes. Water that sits in the cabinet can rust the burner area and heat exchanger, short out the control board, and trip the safety switch that shuts the furnace down. Many high-efficiency furnaces have a pressure switch or float switch that stops heating when water backs up, which is why a leak often shows up as "no heat" on a cold morning. Leaks also damage ceilings below attic furnaces and floors in closets and basements. Fixing a clogged trap or bad pump is usually a quick furnace repair. If years of leaking have rusted out the furnace, our guide on repairing or replacing a furnace can help you decide.
How to Prevent Furnace Leaks
Most leaks start with a dirty trap or drain line, and both get cleaned and checked during a heating tune-up. Our service plan is $159 per year for the first system and $60 for each additional unit, and members get priority scheduling. Learn more about our maintenance plans.
Furnace Leak Repair in Atlanta and Nearby Cities
The Air Company of GA is a family-owned Bryant dealer with NATE-certified technicians. We repair and install furnaces and heat pumps for homes and businesses in Atlanta (including Buckhead, Midtown and Virginia-Highland), Sandy Springs, Marietta, East Cobb, Smyrna, Vinings, Roswell, Alpharetta, Johns Creek, Duluth, Norcross, Peachtree Corners, Brookhaven, Dunwoody, Chamblee, Doraville, Tucker and Decatur. Call 404-583-7788 or contact us online.
Furnace Leaking Water FAQ
Is it normal for a furnace to leak water?
No. A high-efficiency furnace makes water, but it should all go down the drain. Water on the floor means the trap, drain line, pump or vent pipe has a problem.
Why is my furnace leaking water when the heat is on?
The most common causes are a clogged condensate trap, a blocked or loose drain line, or a failed condensate pump. In a cold snap, a drain line in an attic or garage can also freeze.
Is a leaking furnace dangerous?
It can be. Water can short the control board and rust the heat exchanger, and a leak from the vent pipe can mean exhaust isn't venting properly. Turn the system off and have it checked.
Can I still run my furnace if it's leaking?
It's best to turn it off. Running it keeps making water, can damage parts and ceilings, and many furnaces will shut themselves off when water backs up anyway.
Why is my furnace leaking water and not heating?
Many high-efficiency furnaces have a safety switch that stops the burners when condensate backs up. Clearing the clog or replacing a failed pump often gets the heat back on.
Who repairs leaking furnaces in Atlanta?
The Air Company of GA is a family-owned Bryant dealer with NATE-certified technicians, open 24 hours. Call 404-583-7788 for residential or commercial heating service.